£8.99

Application: Discovery 1 1995 to 1998 approx, where fitted with original immobilisation and alarm system.
Description: Small wiring harness to bypass the "spider" .
See http://forums.lr4x4.com/index.php?showtopic=86 for full instructions on how to fit.
find out more

£8.99

Application: Defender 2001 to 2006 with the facelift dash.
Description: Connector kit for auxillary switches on centre dash. This is a direct fit to the front fog lamp switch YUG000540LNF, but will fit the other switches if the splines are removed with a small sharp blade such as a modelling scalpel.
find out more

£3.49

Application: Single pole bulb holders on Defender 1995 onwards, Discovery 1, Discovery 2, Range Rover Classic late,and Range Rover 38A 1995 to 2001.
Description: Connection kit for replacing plug that connects to single pole bulb holder XPB100180.
find out more

£1.54

Application: Series 1, Series 2, Series 2A, Series 3 Land Rovers. All Defenders, Classic Range Rover, Range Rover 2 (38A), Discovery 1 and Discovery 2.
Description: Set of four 3/8UNF x 1.125" long bolts plus four short nyloc nuts.
find out more

£18.60

Replacement Jate Ring with fixing bolt, nut and spacing washer. Standard equipment on military Defenders. Fixes to chassis rail at front or rear of vehicle. Uses existing mounting holes, so no drilling required.
Application: Defender, Classic Range Rover and Discovery 1.

find out more

£34.20

Application: Series 1 - 3, Range Rover Classic, Discovery 1 and Defender. 
Description: 52mm deep socket, 1/2" drive for hub locking nuts.



find out more

£40.98

Application: Series 1 2.0litre engine 1952 to 1958 fitted with Solex 32PBI-2 carburettor. Zenith part number ZRK17.
Description: A fairly comprehensive kit of parts to rebuild this carburettor.

Sorry, temporarily unavailable until a material is found for pump diaphragm that is compatable with ethanol.
find out more

£162.11

Standard Set Plus of Polybush covers both ends of front radius arms, both ends of rear lower link, Panhard rod bushes, plus rear 'A' frame to chassis.
Application: Defender 1994 to 2001, Classic Range Rover 1986 to 1995, Discovery I 1989 to 1999.
Available in Classic and Comfort Formulas.
find out more

£23.94

Application: Defender rear from approx 1985 to 1993, Discovery 1 to 'JA' chassis number (1992) front and rear, Range Rover Classic 1985 to 1995 non-ABS front and rear.
Description: Kit of parts to service one wheel hub. Kit comprises a pair of Timken wheel bearings, Gaco inner seal, replacement outer seal, seal spacer, 2x flange gaskets and hub nut locker.
find out more

£15.95

We have limited stock of "New - Old Stock" of this book published in 1993 by Land Rover.
Sub-titled "A user's guide to four-wheel driving", the aim of this book is to make the operation of all Land Rover products, both on and off road, more effective, easier and safer. It is aimed at all users - from seasoned fleet operators in remote areas to the person driving their first four-wheel drive vehicle.
The book is split into 7 sections and each section is subdivided into several chapters. Section titles are; Sec1: 4x4 Ingredients, Sec2: Enhanced Traction, Sec3: Ops - Preliminaries, Sec4: Ops - The Details, Sec5: Ops - Recovery, Sec6: Advanced Driving, Sec7: Data.
Hard back book with dust cover measuring 25.4cm(10") high by 20cm(7.9") wide. 164 pages with many photos and diagrams.
find out more

£14.88

Application: Freelander One with petrol (gasolene) engines.
Description: Genuine air bleed hose and 'tee' peice assembly. Allows air from top of radiator to escape to expansion bottle.
Approximate dimensions: Overall length 44cm(17.3"), inside diameter 20mm(0.8")
find out more

£24.95

Application: Freelander One with M47 (TD4) diesel engine.
Description: Genuine Hose from intercooler to inlet manifold.
Approximate dimensions: Overall length 44.5cm(17.5"), inside diameter 4.7cm(1.85")
find out more

£17.47

Application: Series 1 1.6ltr & 2.0ltr petrol engines.
Description: Water outlet on top of engine over thermostat.
find out more

£13.26

Application: Freelander One to 'YA'.
Description: Replacement set of four brake shoes for rear of Freelander One to approximately 2000.
Approximate dimensions: Each shoe measures 23cm(9.1") edge to edge and is 3.7cm(1.5") wide.
find out more

£58.33

Application: Freelander One to 'YA'.
Description: Genuine set of four brake shoes for rear of Freelander One to approximately 2000.
Approximate dimensions: Each shoe measures 23cm(9.1") edge to edge and is 3.7cm(1.5") wide.
find out more

£10.75

Application: Freelander One from '1A'.
Description: Genuine set of return springs (pull-off springs) for rear brakes from approx 2001 onwards. Kit is for both rear wheels.
Approximate dimensions: 2 springs 12.3cm(4.8") long, 2 springs 7.2cm(2.8") long, 1 spring 13cm(5.1") long and 2 springs 4.5cm(1.8").

find out more

£9.42

Application: Freelander One from '1A' onwards.
Description: Original Equipment rear wheel cylinder for vehicles from 2001 approximately. These cylinders are not handed.
Approximate dimensions: Casting length 6cm(2.4")
find out more

£4.54

Application: Freelander One.
Description: Genuine set of pins and clips for retaining rear brake shoes to backplates.
Approximate dimensions: Pins are 28mm(1.1") long.
find out more